Output/Preview Window
I accidentally closed my output/preview window in my workbench, how do i get it back?
I was trying to find an option but didn't see any.
Thanks.
Best Answer
-
some jobs ran fine as they are running daily. there was one that failed.
I had to re-install my workbench and reconfigure it to make it work. Its working now...
0
Answers
-
You should have a small tab at the bottom left of your screen that has "Preview" and another that says "Output". If you hit the X in the preview pane and it shows up and is just blank, hit the "Preview" eye at the top on the menu bar and that should work.
0 -
-
You don't have Preview at the top showing because you aren't focused on a job...so if you expand the jobs and highlight one you'd get that option showing back at the top...if not close and reopen workbench.
I'd try to close/reopen workbench if that doesn't work.
If all else fails, think about what version of workbench you're on. I can't remember problems with older versions, but I always see Preview/Output in mine..so it may be something up with the version you are on....but that is just a guess.
0 -
it was there this morning but i accidentally clicked on close on that tab
I tried to close and re-open workbench, didn't work.
preview button works when i focus on a job but it doesn't show the preview or the ouput even when i click on preview or run.
my workbench version is 4.62.6715.32090
0 -
And the job has no errors and ran fine? Did you look over the logs?
0
