identifying column of join data
let me know if domo checks all of [identifying column] when join data.
I tried to join data with attached [TestData.xlsx], then got no result.
I know when i put mached ID ahead of the Data1, I can get joined data, while mached ID are not always ahead of the data set actually.
with above result i wonder if DOMO checks only ahead ID of data set.
0
Best Answer
-
This join should work. I know the preview when using ETL is not searching the entire data set, but I had assumed it was searching further than 100 rows of data. Do you get the same result when you save and run the entire data flow?
______________________________________________________________________________________________
“There is a superhero in all of us, we just need the courage to put on the cape.” -Superman
______________________________________________________________________________________________1
Answers
-
Thank you for your help!
I could have joined data after RUN and SAVE!
Thank you again for your help.
0
Categories
- 10.8K All Categories
- 3 Private Company Board
- 1 APAC User Group
- 12 Welcome
- 39 Domo News
- 9.7K Using Domo
- 1.9K Dataflows
- 2.5K Card Building
- 2.2K Ideas Exchange
- 1.2K Connectors
- 343 Workbench
- 260 Domo Best Practices
- 11 Domo Certification
- 464 Domo Developer
- 50 Domo Everywhere
- 105 Apps
- 714 New to Domo
- 85 Dojo
- Domopalooza
- 1.1K 日本支部
- 4 道場-日本支部へようこそ
- 27 お知らせ
- 64 Kowaza
- 299 仲間に相談
- 653 ひらめき共有