Failed Dataflow Status
When my dataflow fails, I go to that dataflow. I then click the red FAILED icon. There I see a list of each function in my dataflow. Next to each action I see that same red FAILED icon. It appears that each and every function was not configured properly and did not executre. If I hover over each of them it says "No Additional Details" until I however over the one that is the problem.
From a user perspective, it makes troubleshooting difficult. I have to run down the list until I find the problem. Here are two possible fixes to make this easier
1) Use the SUCCESSFUL/FAILED icon set at the function level, rather than the dataflow level when looking at details. That way, I can just scan and quickly see which function has a problem.
2) Add a text collumn that shows me the reason for failure at the function level. That way, I don't have to hover over each to see what failed and why.
Categories
- 10.8K All Categories
- 3 Private Company Board
- 1 APAC User Group
- 12 Welcome
- 39 Domo News
- 9.7K Using Domo
- 1.9K Dataflows
- 2.5K Card Building
- 2.2K Ideas Exchange
- 1.2K Connectors
- 343 Workbench
- 260 Domo Best Practices
- 11 Domo Certification
- 465 Domo Developer
- 50 Domo Everywhere
- 106 Apps
- 717 New to Domo
- 85 Dojo
- Domopalooza
- 1.1K 日本支部
- 4 道場-日本支部へようこそ
- 27 お知らせ
- 64 Kowaza
- 299 仲間に相談
- 654 ひらめき共有